Definition
ASME Section VIII is the division of the ASME Boiler and Pressure Vessel Code that covers the design, fabrication, inspection, testing, and certification of unfired pressure vessels — containers designed to hold fluids at pressures above 15 psig. It is published by the American Society of Mechanical Engineers and is widely adopted by jurisdictions in the United States, Canada, and internationally as the governing standard for industrial pressure vessels. Section VIII has three divisions: Division 1 (design-by-rule, the most common), Division 2 (alternative rules with higher allowable stresses), and Division 3 (for very high pressure above approximately 10,000 psi).
Section VIII is the baseline certification for the vast majority of pressure vessel procurement. The ASME U stamp issued under Section VIII is required by many jurisdictions, insurance underwriters, and owner specifications as a condition of vessel installation and operation. Understanding which Division applies to a given project — and what the code requires in terms of NDE, PWHT, documentation, and data reporting — is foundational to scoping a pressure vessel RFQ accurately.
MRX fabricates pressure vessels, heat exchanger shells, process reactors, and specialty containers to ASME Section VIII Division 1. The U stamp and associated ASME U1/U1A data report are standard deliverables for MRX pressure vessel scopes. Material certification, weld procedure qualification, and hydrostatic test documentation are produced as part of every Section VIII fabrication package.
“ASME Section VIII and Section III cover the same vessels.”
Section III applies exclusively to nuclear facility components with formal safety classifications. Section VIII covers virtually all other industrial pressure vessels.
“The ASME U stamp guarantees the vessel is fit for the intended service.”
The U stamp confirms that the vessel was designed and fabricated to code requirements based on the specified design conditions. Fit for service also depends on a correct and complete process specification from the buyer.
“All Divisions of Section VIII are equivalent in cost.”
Division 2 requires more engineering analysis and more extensive NDE than Division 1. The higher design allowables of Div. 2 may save wall thickness and material for large, high-pressure vessels, but the added engineering and inspection cost must be offset by those savings.
Pressure Vessel Buyer's Guide
Comprehensive procurement guide covering Section VIII scope, stamp requirements, and RFQ checklist
2026 ASME BPVC Key Changes
What changed in the 2026 BPVC edition and what it means for pressure vessel specifications
Section III vs. Section VIII Deep Dive
Full comparison of nuclear and general-industrial code paths
ASME Code FAQ
Buyer FAQ on code selection, Div. 1 vs. Div. 2, and certification costs
Pressure Vessels, Tanks & Reactors — MRX
MRX fabrication capabilities for ASME-stamped pressure vessels
MRX Manufacturing is a custom industrial fabricator based in Canby, Oregon. Talk to our engineering team about your project scope.